Stainless Steel Axial-Flow Submersible Pumps

Stainless Steel Axial-Flow Submersible Pumps

Home Up Strainer Screens Other Pump Accessories Liquid Level Controls Plumbing Accessories Electrical Controls

Other Pump Accessories

INTAKE HORNS

Intake Horns are available on horizontal pumps only. The horns direct the flow of water and allow the pumps to pump closer to the bottom of the sump.  PVC Intake Horns are lightweight and economical. The PVC Intake Horn attaches to the pump shell with stainless steel bolts. No gaskets are required.

Intake horns are available as a factory installed option only.

 

PUMP RINGS

Pump rings are additional stainless steel rings that are welded to the bottom flare of the 4" and 6" Stainless Steel Axial Flow Submersible vertical pumps. These rings widen the area of the pump base and increase the suction power of the pump. Pump rings are used to reduce the minimum submergence requirements of the pump. This allows the pump to pump the water down further than a pump without a pump ring.

These rings are not recommended for use with strainer screens. Pump rings are a factory installed option only.

 

MOTOR LEADS

All Carry Stainless Steel Axial-Flow Submersible pumps come with 30' of motor lead standard. Occasionally additional lengths are required for the application. Please specify when ordering.  Please note:  as the distance between the pump and the control panel increases the voltage drop in the lead also increases.  Please see the Franklin Electric Motor Manual, pages 11 and 16 for more information on the maximum length each cable size can be used for.

 

 

LIFT CHAIN/WIRE ROPE ASSEMBLIES

A Lift Chain can be attached to the Stainless Steel Axial-Flow Submersible pumps to ease installation and removal from the wet well or sump. Lift Chain is available in either 304 stainless steel or hot dipped galvanized steel chain, available in 3/16" links and sold by the foot. 

Wire Rope assemblies can be used to ease installation and removal from the wet well or sump. The assemblies are available in four standard lengths - 6', 10', 16' or 20'. Other lengths are available, please consult the factory for details. All wire rope assemblies have 7 x 19 wire rope construction. Wire Rope Assemblies are available in Galvanized Steel Bare Wire, Galvanized Steel Nylon Coated Wire, 304 Stainless Steel Bare Wire or 304 Stainless Steel Nylon Coated Wire.  Galvanized steel assemblies have zinc plated steel fittings; stainless steel assemblies have stainless steel fittings.

 

 

QUICK LINKS

The threaded chain connectors are used to connect the lift chain or wire rope assemblies to the lift lugs of the Stainless Steel Axial-Flow Submersible pumps. No tools are needed to attach these re-usable threaded connectors. They have a wide jaw to accommodate large fittings. They are available in either zinc plated steel or 316 stainless steel, standard or pear shaped.

 

 

Carry Manufacturing, Inc., 1514 S. Knight Road, Munger, MI  48747-9703
989-659-3500 or 800-49-CARRY (800-492-2779) fax:  989-659-3506
General Information: carrymfg@aol.com